Development of porous Ti6Al4V samples by microsphere sintering
Identificadores
Compartir
Estadísticas
Ver Estadísticas de usoMetadatos
Mostrar el registro completo del ítemAutor
Fecha
2012Materia/s Unesco
3328.16 Transferencia de Calor
3305.90 Transmisión de Calor en la Edificación
Resumen
Two differently sized microspheres were sintered at 1300 °C and 1400 °C from 2 to 8 h in stoneware, alumina, yttria and zirconia moulds. Selecting the appropriate material to be used as a mould remains a critical issue given titanium's high reactivity at elevated temperatures. Optimum mechanical properties were obtained when sintering the smallest microspheres in yttria-coated moulds. Stiffness of the samples was lower than 40% of that of the bulk solid material, which comes closer to that of human cortical bone. Open and interconnected porosity was observed in all the specimens. © 2011 Elsevier B.V. All rights reserved.
Two differently sized microspheres were sintered at 1300 °C and 1400 °C from 2 to 8 h in stoneware, alumina, yttria and zirconia moulds. Selecting the appropriate material to be used as a mould remains a critical issue given titanium's high reactivity at elevated temperatures. Optimum mechanical properties were obtained when sintering the smallest microspheres in yttria-coated moulds. Stiffness of the samples was lower than 40% of that of the bulk solid material, which comes closer to that of human cortical bone. Open and interconnected porosity was observed in all the specimens. © 2011 Elsevier B.V. All rights reserved.
Colecciones
